Multiwii FPV

Partners

Viewed products

Ensemble...
AQ50 PRO...

AQ50 PRO board ready to use With the ...

Information

BMA 180 , ITG 3200 , USB TLL , included ;)

More details

More info
Comments (0)

New 1.9 Modified SOFTWARE for THIS BOARD

http://www.skanowanie.com.pl/tmp/MultiWii_1_9q.zip

Advanced MultiWii FPV flying controller.

Thanks to using hi quality sensors (ITG3200 and BMA180)
this controller offer you high flight stability in acro and auto level mode.

Firmware: Typically we send this controller with firmware in QUAD X mode.
Send us a short info if you want different flying mode.

We highly recomend www.multiwii.com pages,
especially "Operating the multicopter" section. You should read this page first!

Our project has a few futures which you will not found in other boards:

Smart power system.
You don't need to use external BEC as a power source.
In our board first ESC power first servo (only), second ESC power second serwo (only).

If you will fly in TRIcopter mode third ESC will power rear servo (only).

In quad mode you should remove positive wire (+5V) from third or fourth ESC.
Thats all - you don't need external BEC :)

Fast and easy gimbal setup.
Thanks to onboard potentiometers and our software you can configure your gimbal
without changing anything in source code. If you are using ordinary MultiWii controller
you must modify source code, connect board to the PC and program with modified code
if you want to setup gimbal stabilisation. With our controller is much more easy - look at this video:

No customer comments for the moment.

Only registered users can post a new comment.